Most of electronics projects are related with microcontrollers and programming. Among these projects many of them are programmed using Arduino due to the user friendliness of Arduino coding. Even a beginner can quickly learn to code Arduino for a deeper level. But some of the projects like university or college projects cannot have an Arduino board within the project due to limitations from the academic staffs. For that kind of cases we can still use Arduino programming to program Atmega 328PU IC microcontroller which is the same controller IC within the Arduino UNO board.
Here we are using an Arduino UNO board to program the Atmega 328PU chip. UNO board is acting as an ISP (In System Programming) programmer to program the chip on a bread board or on a PCB. This method allows to program a microcontroller while it is installed in a system.
Step1:
Open Arduino IDE and go to Examples => ArduinoISP
and there you can see the ArduinoISP
example sketch.
Open this
sketch in a new tab and upload it to the Arduino board which you are going to
use as the ISP programmer.
Step2:
After a successful uploading, connect your ATMega328p
chip to several other components as following image. Here I have used an Arduino
Uno board as the programmer. But you can use any other Arduino board for this.
In that case pin connecting diagram will be differ according to the chip of the
Arduino board.
There are two methods for the next step.
a.
The ATMega chip on
the programmer Arduino board should be removed from the board.
b. But if you have an Arduino clone board with a
non-removable surface mounted Atmega chip, you need to connect the reset pin of
the programmer Arduino board to the ground through a capacitor (here I used a
10uF one) as the image shown
Step 3:
If your target ATMEGA 328P does not contain the
Arduino bootloader, you need to upload it as follows. (If your 328P chip
already contain the bootloader, you can skip this step).
Go to Tools=> programmer and then select
‘Arduino as ISP’
Arduino board as an ISP programmer
1 Now you already have an Atmega 328 chip with the boot
loader. Next step is to program this chip using
an Arduino board as an ISP programmer.
Open the Arduino sketch which you want to upload.
Connect the chip in the same configuration in above figures which you used to upload
the bootloader. You need to upload ArduinoISP to the Arduino board and select
programmer as ‘Arduino as ISP’ from tools tab.
Then go to the sketch tab and click on ‘Upload Using
Programmer’. It will upload the sketch to the chip on the breadboard.
